Saturday, October 3, 2015

September 2015

After a lot of sanding and priming, we have Awlgrip topcoat on the bead board.  The majority of the wiring is in place for the 110v circuits, and we are getting the lighting laid out.
We'll be switching gears to outdoors work now that it has cooled off.  

Thursday, July 16, 2015

Bead Board is going up...

It has been sanded, filled and ready for primer.

Monday, June 15, 2015

June 2015

This months work has involved furring the walls to a plumb straight line on port and starboard side of the upper cabin.  Noel's exterior is framed in a curve, and in order to make up that curve the framing of the walls tilts inward about a inch and a half along the height of her cabin.  We straightened the interior to provide a chase way for a pair of 16.5k btu air conditioners,  Between the two center windows, we have gained a 3 inch deep cavity that will allow us to run a split system in the upper cabin.  The fir plywood you see, will be getting a bead board wainscot up to the window edge, with a molded chair rail. The upper area above the windows will be boxed outward for chase ways and duct work.  By keeping the full size sheets across it made it much easier to transcribe the line from the sole upward.  That made sure the walls ended up both flat and plumb to both themselves and the new flat cabin sole. 

Editors note:  Cell phone camera lenses twist straight lines!   

Wednesday, May 20, 2015

May 2015

Making a little more progress...  The sole is now flat and level.  We'll be insulating, wiring and laying bead board for the next few weeks...

Wednesday, May 6, 2015

April 2015

This month we've been working on leveling and sound insulating the cabin sole in the cabin house.  Noel has a cambered deck, we are leveling it out so it is a more comfortable space.  We are also believing that it will pay back a dividend when it comes to building the interior cabinets. 

We are working through the last of the heavy lifting projects that require the big tools to be on board, which has required some heavy lifting of its self!  

That meant that the wood shop has been moved around, all the tools and equipment shifted from the front to the back, and then vice versa.

This is the aft end of the cabin, we are in the process of moving everything back there to do the middle... 

Wednesday, March 4, 2015

March 2015

We've reached the fun stage of the build...  Where other than pulling a new bundle of wires, and swapping out a sensor here, or gauge there it is tough to see where the spools of cable are going.

The engines paint jobs are finished, and the raw water is hooked back up.  We've got new strainers ready to go, and exhaust systems pending review. 

The steering hoses are being pulled, and the shifter cables are in place.  The synchronizer is hooked up...

The crash bilge pump manifold is sweated back together, and the piping reinstalled.  

In short, it's a long hit list from an empty boat hull to a running one, but we are trying to go about it in a logical manner so that what needs to go to each place is getting pulled before the components at each end are laid out with plenty of room to grow.  In other words, we are at the squirrels nest period of wiring where each wire is only to long, once while final positions and chase ways are defined.

Thanks for following along,